PAC-TPL - Seaward 3 Phase Leakage Adaptor (5 pin 20A & 32A)

A 5 pin, 20/32Amp, 3 Phase Leakage Adaptor designed for use with the following Seaward Appliance Testers:

• PAC3760 Plus (Firmware Version 1.08 or Higher)
• PAC3760 Plus II
• PAC3760DL
• Primetest Elite (Protag Elite)

The ProTag PAC-TPL 3 phase leakage adaptor allows users of the Seaward systems mentioned above to power up 10A, 16A, 20A, and 32A appliances while carrying out a leakage current test. The test results are displayed on the Seaward unit, showing both the actual reading and a Pass/Fail indication.

Most three-phase equipment incorporates electronic circuitry, such as temperature controls, PLCs that manage relays, or motors requiring starter circuits like contactors. All these controls, contactors, and relays must be powered on to latch. Performing an insulation resistance test will only verify up to the on/off switch, failing to show any internal faults. The PAC-TPL three-phase adaptors enable the compatible Seaward Appliance Tester to power up the 3-phase appliance under test, with results indicated on the Appliance Tester screen.

• PAC-TPL: 20A/32A, 500V, 50Hz
• Earth Continuity: Refer to your Seaward Test Instrument specification
• Test Voltage: 3 phase supply voltage
• Test Duration: Continuous
• Display Range: 0.15mA to 9.99mA
• Measurement Range: 0.25mA to 9.99mA
• Accuracy: ±(5% + 2 digits)
• Frequency Response: 50Hz
• Pass Value: 5mA

The PAC-TPL is ONLY suitable for use with the Seaward testers listed above. The PAC3760 Plus must run the correct version of the firmware (V1.08 or Higher) to enable use of this adaptor.